Video link: https://youtu.be/4vAEYBrnFPM

Video Summary

This video provides a simplified guide based on the text overlay and transcript for how to remove and install the door handle on a Harvest Right Freeze Dryer

Video Transcript

Tools Needed:

• 10mm wrench
• 27mm socket or 10in crescent wrench

Removing the Door Handle:

1. Remove Bolt and Tab: Use a 10mm wrench to remove the bolt and tab from the handle.
   1. Transcript Note: Loosen the bolt with a 10mm wrench to remove the tab.
2. Remove Large Nut: Use either a 27mm socket or a 10in crescent wrench to remove the large nut holding the handle onto the door.
   1. Transcript Note: The nut should not be very tight. Once it's off, you can remove the handle.

Re-Installing the Door Handle:

1. Place Rubber Washer: If your handle has a rubber washer, place it on the door handle.
   1. Transcript Note: The rubber washer is optional based on your specific model.
2. Insert Handle: Insert the door handle into the hole in the replacement door.
   1. Transcript Note: Align the handle correctly by using the tab as a guide.
3. Install Large Nut: Use a 27mm socket or a 10in crescent wrench to place the large nut onto the door handle and tighten it.
   1. Transcript Note: It needs to be snug, not super tight.
4. Install Bolt and Tab: Place the tab and install the corresponding 10mm bolt.
   1. Transcript Note: Once the bolt is hand-tight, use a 10mm wrench to snug it down. Verify the handle latches correctly.

This guide integrates both the text overlay and the video transcript to provide a comprehensive set of instructions.