Operating the impulse sealer that comes with your Harvest Right freeze dryer is a straightforward process. Here's a quick guide on how to use it:
- Plug In the Sealer: Connect the impulse sealer to a power outlet.
- Adjust the Heat Setting: Set the heat sealing time according to the thickness of the plastic bags you are using. This is usually done by turning a dial or knob on the sealer to select the desired time (e.g., 1.5 seconds for thinner bags, 3 seconds for standard bags).
- Place the Bag: Open the arm of the impulse sealer and place the open end of the plastic bag across the sealing element.
- Seal the Bag: Press down the arm to initiate the sealing process. Hold the arm down until the indicator light turns off, signaling that the sealing is complete.
- Release and Inspect: Release the arm and remove the bag. Check the seal to ensure it is complete and consistent across the bag's opening.
- Adjust if Necessary: If the seal is not satisfactory, adjust the heat setting and try again with a new section of the bag or a new bag altogether.
Remember, the longer the sealing time, the hotter the sealer gets, which can result in a stronger seal. However, setting the time too long can burn through the bag, so it may take a few tries to find the perfect setting for your bags.
If you encounter any issues with the impulse sealer or if it's not sealing properly, ensure that the sealing wire is intact and not damaged. These components can wear out over time and may need to be replaced to maintain a good seal.
